Compix Analog - Manual (Page 6)

Document No: 2.3.008 Revision: 1.0 Updated: 5/8/2012
Steps to Success
2
Introduction
Before utilizing the Compix software, we will need to configure the
drivers properly for setup within the studio. Going through this con-
figuration setup is vital for a successful installation.
To continue, connect the Compix Video Output to a monitor or call it
up on your switcher for manipulation. Open the AllCG Control short-
cut located on the Desktop. The below interface will appear:
The AllCG Control can be broken down into sections: Mode, Output
Control, Color Control, Video-Out Control, and Test Frame which
includes Frame Grab.
Mode Section
Video Format: Select whether your are integrated for an NTSC or
PAL environment.