Compix Analog - Manual (Page 4)

Document No: 2.3.008 Revision: 1.0 Updated: 5/8/2012
Downstream Connection
Advantages:
1. Not required to use any inputs on the switcher.
2. Simple installation with minimal cabling.
3. CG operator can take graphics to air.
Things to Consider:
1. It is recommended to keep the Compix system running at all
times throughout usage.
2. Preview only available through the Compix software.
How to Connect - Single Channel:
1. Take the Program Output of the switcher into the Video-In
(V-In) connector.
2. Take the Video-Out (CVBS-1) into the Program Monitor.
3. Refer to the Steps to Success chapter.
How to Connect - Dual Channel:
1. Take the Program Output of the switcher into the Video-In
(V-In) connector.
2. Loop the First Channel’s Video Out (CVBS-1) into the Sec-
ond Channel’s Video-In (V-In).
3. Take the Second Channel’s Video-Out (CVBS-1) into the
Program Monitor.
4. Refer to the Steps to Success chapter.
CVBS-1 Out
V-In
Compix System
CVBS-1 Out
V-In
Production Studio
Compix Program Mon
Channel 1
Channel 2
Compix System
CVBS-1 Out
V-In
Production Studio
Compix Program Mon
Single Channel Configuration Dual Channel Configuration