Dimplex DF2622SS - Manual (Page 15)

15
Maintenance
Figure 9
Flicker rod
Light Filter
Bracket screws (2)
Lower Light
Bulbs (3)
Light Block
Light Block screws (4)
clockwise.
replace light filter bracket
12.
and flicker rod.
Install the log set assembly by
13.
placing the front, bottom edge
of the ember bed in the track
behind the control panel.
once in place, push down on
the back edge of the ember
bed until the rear tab snaps
into place under the mirror
(Figure 8).
! NOTE: Ensure the log set
Assembly is installed tightly under
the bottom edge of the mirror to
prevent light leakage.
Lay unit on it’s back and slide 14.
Front Glass back into position
and attach trim.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 25 Watts per
bulb.
To access the upper light bulb
area:
slide fireplace out of mantel. 1.
Lay unit on it’s back for safe 2.
removal of front glass.
Remove three (3) Phillips
3.
screws from right side of trim.
remove trim.
4.
Slide glass to the right side 5.