BIXOLON SRP-330 - Manual (Page 18)

Rev. 1.05 - 18 -
SRP-330
1-6 Recommended Papers
- TF50KS- E (Paper Thickness: 65μm): Nippon Paper Industries Co., Ltd.
-
PD 160R (Paper Thickness: 75μm): New Oji Paper Mfg. Co., Ltd.
-
P350 (Paper Thickness: 62μm): Kansaki Specialty Paper, Inc. (USA)
※ CAUTION
Use of papers other than those recommended above may damage TPH or degrade the
printing quality and our company is not responsible for the damage caused by non-
recommended papers. If you have to use other products, we recommend that you use
papers with a similar level of quality to the recommended ones.
1-7 Using the Printer
1-7-1 Control Panel
1-7-2 Mounting
2” Partition
Hang the partition at the front and press down the rear to mount the 2” partition as shown in
the picture.
※ CAUTION
After using 2"(58mm) paper roll, do not replace it with 3"(79.5±0.5mm) paper roll.
○ POWER
The POWER light is on whenever the printer is on.
○ ERROR
This indicates an error.
○ PAPER
This light indicates the near end of the paper roll. Install a new
paper roll and the printer will continue printing. When the light
blinks, it indicates the self-test printing standby state or macro
execution Standby state when the macro execution command is
used.
○ FEED
Press the FEED button once to advance paper one line. You can
also hold down the FEED button to feed paper continuously.