Audio Solutions TVAM2-1 - Manual (Page 20)

21
Turn the TV Audio Mount System ON/OFF
LINE
Select the source to Line In
OPT
Select the audio source to Op cal
Select hearing impaired or standard mode
MUTE Mute the audio
BASS- Decrease the Bass
BASS+
Increase the Bass
TREB-
Decrease the Treble
TREB+
Increase the Treble
BAL-L Move the Balance to the le
BAL-R Move the Balance to the right
VOL+
Increase Volume
VOL-
Decrease Volume
Remote Control LED/Sensor Location
The remote sensor that controls the TV Audio Mount system is located at the bo om of the right speaker.
When a emp ng to use the remote control with the system, be sure to point it toward the remote sensor.
Do not place any obstacles between the remote control and the remote sensor on the speaker. The
eff ec ve range of the remote control is approximately 30 feet from the front of the speaker.
Remote Control Precautions
• The remote control should be kept dry and away from heat sources. Avoid high humidity.
• If the TV Audio Mount System responds erra cally to the remote control or does not respond at all,
please check the ba eries. If the ba eries are low or exhausted, replace with 2 fresh ba eries.
• Do not take the ba eries apart or expose to heat. Never dispose of ba eries in a fi re.
• Do not subject the remote to undue physical stress, such as dropping or striking it.
• Do not clean the remote with a vola le solvent. Wipe it clean with a damp cloth.
REMOTE CONTROL