Rs-232 – Atlona AT HDVS RX User Manual
Page 7
7
RS-232
Connection
RS-232 is connected through a 9-pin female DB connector. Only pins 2, 3, and 5 are terminated.
No.
Pin
Function
1
----
Not used
2
Rx
Receiver
3
Tx
Transmit
4
----
Not used
5
Gnd
Ground
6
----
Not used
7
----
Not used
8
----
Not used
9
----
Not used
1
2
3
4
5
9 8 7 6
Set Up
1. Connect the receiver to a PC using a 9 pin serial to USB adapter
Note: Receiver must be disconnected from the display for RS-232 set up
2. Go to the device manager folder (see picture A) on your computer
3. Find the receiver COM port.
NOTE: If unsure which COM port is connected, unplug the USB cable and plug it back in. It
will disappear and reappear on the COM port list.
4. Open software (see picture B), select the correct comport, and press connect.
Control software and instructions for ease of use can be found on the AT-HDVS-RX webpage on
atlona.com.
URL: http://www.atlona.com/HDVS-RX.html (
instructions/software found under the “Downloads” tab
)
Control Software
A
B
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515