Atlona AT HDVS RX - Manual (Page 10)

10
Commands
The command codes are case sensitive, do not change capitalization, spacing, or lettering.
Command Parameters Description
WP_DisplaySet[a,b,c,d]$
WP_DisplaySet[?]$ [a] baud rate: 2400 , 9600 , 19200 , 38400 ,
56000 , 57600 , 115200
[b] data bit: 5 , 6 , 7 , 8
[c] parity: N (None) , O (Odd) , E (Even) , M
(Mark) , S (Space)
[d] stop bit: 1 , 1.5 , 2 Set projector’s RS-232 port
WP_DisplayOn[a,b]$
WP_DisplayOn[?]$ [a] command length.
carriage return is computed, if it has one.
Max. command length is 50
[b]command string.
Include carriage return, if it has one.
Supports multi-command in a command string.
Supports delay-command COMMA
(a comma=5 sec) Set projector’s Display On command
WP_DisplayOff[a,b]$
WP_DisplayOff[?]$ [a] command length.
carriage return is computed, if it has one.
Max. command length is 50
[b]command string.
Include carriage return, if it has one
Supports multi-command in a command string.
Supports delay-command COMMA
(a comma=5 sec) Set projector’s Display Off command
WP_IdentifyTx[a]$ [a] ? Identify Tx model; reply TX=AT-HDVS-
TX, TXWP=AT-HDVS-TX-WP
WP_Input[a]$ [a] ? , Hdmi1 , Hdmi2 , Vga Select input source
WP_Input[a]$ [a] ? , Hdmi , Vga Select input source
WP_Display[a]$ [a] ? , On , Off Display On/Off control
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515