Atlona AT HDVS RX User Manual
Page 11
11
Note:
1. Each command and feedback is terminated with a carriage return.
2. Spaces aren’t allowed except in projector display on/off command strings.
3. AT-HDVS-RX RS-232 port settings:
115200 bps, 8 bit data length, No parity bit, 1 bit stop-bit, No flow control.
4. Feedback for a command repeats the original command.
5. If a command fails or is aborted, the feedback will be “COMMAND FAIL”.
6. Some commands support query function by parameter [?]
Example: To get projector’s display on command -> WP_DisplayOn[?]$
To get input status -> WP_Input[?]$
Commands cont.
WP_DisplayMode[a]$
[a] ? , DispSWAVOn , DispSWAVSW , AVSW ,
AlwaysOn
Set display mode
WP_Aspect[a]$
[a] ? , Full , 16:9 , 16:10 , 4:3 , Keep
Select output aspect ratio
WP_AutoSwitch[a]$
[a] ? , On, Off
Input Auto Switch enable/disable
WP_VgaAuto[a]$
[a] Go
Run VGA source auto-adjust
WP_VgaClock[a]$
[a] ? , Normal , Inverse
Set VGA ADC clock polarity
WP_Info[a]$
[a] ?
Get WPRX firmware version
WP_Output[a]$
[a] ? , 0 , 1 , 2 ... (map osd menu Output list)
Select output resolution
WP_OverscanEn[a]$
[a] ? , Yes , No
Set overscan enable/disable
WP_OverscanH[a]$
[a] ? , 0 ~ 50
Set overscan H size (%)
WP_OverscanV[a]$
[a] ? , 0 ~ 50
Set overscan V size (%)
WP_AudioEn[a]$
[a] ? , On , Off
Set audio out On/Off
WP_AudioHdmi[a]$
[a] ? , On , Off
Set hdmi audio out On/Off
WP_AudioLR[a]$
[a] ? , On , Off
Set analog L/R audio out On/Off
WP_SystemRst[a]$
[a] Go
Run system reset
WP_PictureBri[a]$
[a] ? , + , - , 0 ~ 100
Set picture brightness
WP_PictureCon[a]$
[a] ? , + , - , 0 ~ 100
Set picture contrast
WP_PictureSat[a]$
[a] ? , + , - , 0 ~ 100
Set picture saturation
WP_PictureHue[a]$
[a] ? , + , - , 0 ~ 100
Set picture hue
WP_PictureSha[a]$
[a] ? , + , - , 0 ~ 100
Set picture sharpness
WP_PictureRst[a]$
[a] Go
Run picture reset
WP_Standby[a]$
[a] ? , 0 ~ 10
Standby timer in minute
]$
Abort command, Feedback is
COMMAND FAIL
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515