Dell S300w - Manual (Page 43)

Using Your Projector 43
NOTE: To activate 3D Display function, ensure that 3D goggles, 3D video
contents and 60Hz/120Hz signal output graphic card supported on PC/NB are ready.
3D Sync Invert— If you see a discrete or overlapping image while
wearing DLP 3D goggles, you may need to execute 'Invert' to get
best match of left/right image sequence to get the correct image.
(For DLP 3D goggles)
Wireless / Network—Select On to activate wireless / network function. Press
to configure the Wireless / Network settings.
WIRELESS / NETWORK
The Wireless / Network menu allows you to configure the network connection
settings.
DHCP ADDRESS—If a DHCP server exists in the network to which the projector is
connected, the IP address will automatically be acquired when you select DHCP
On. If DHCP is Off, manually set the IP Address, Subnet Mask, and Gateway. Use
to select the number of IP Address, Subnet Mask, and Gateway. Key in
Enter to confirm each number and then use to set the next item.
IP A DDRESS —Automatically or manually assigns the IP address to the projector
connected to the network.