Ip commands – Atlona AT UHD SW 52ED User Manual

Page 16

atlona.com

Toll free: 1-877-536-3976

Local: 1-408-962-0515

Command

Feedback

Description

IPCFG

IP Addr : x.x.x.x
Netmask : x.x.x.x
Gateway : x.x.x.x
IP Port : x

Displays IP address configuration

IPQuit

Logs out of TCP/IP Connection

IPAddUser X Y
Ex. IPAddUser Atlona 1234

TCP/IP user was added

Adds a user for TCP/IP control
X= user and Y= Password

IPAddUser

username password
username password
username password

Displays a list of users and passwords

IPDelUser X

TCP/IP user was deleted

Delete a user from TCP/IP X= username

IPDHCP X

Turns HDCP on or off X= on, off, sta

IPStatic X Y Z
Ex. IPStatic 192.168.1.1
255.255.255.0
192.168.1.200

Sets static IP address
IPStatic Address(X) Netmask(Y) Gateway(Z)

IPPort X

Set the TCP/IP Port

IPLogin X
Ex. IPLogin off

Enables IP Login
X= on, off, sta

Broadcast X
Ex. Broadcast on

Sets broadcast mode on or off
X= on, off, sta

IPTimeout XX
Ex. IPTimeout 300

IPTimeout XX
Ex. IPTimeout300

Determines amount of seconds of inactivity before TCP/IP
disconnects

Each command or feedback is terminated with a carriage return.

Note: If the command fails or is incorrect the feedback is “Command FAILED”

IP Commands

Zone output baud commands

(for display control)

RS232para1[baudrate,data-length,parity,stop-bit]

Example: To change the output baud rate to 19200 use RS232para1[19200,8,0,1]

RS232zone1[command]
Once the switcher and zone output have been set up for the best communication, commands can be sent
to control the display. The commands will come from the user manual of the display or projector. The com-
mands and any carriage returns/line feeds in the commands will need to be placed in the bracket.

Example: To turn the display or projector on if the command is PWRON carriage return, use the command:

RS232zone1[PWRON carriage return]

Note: Use this command if the connected control system does not output 115200

Note: Use this command if the connected display uses a different baud rate

Baud Rate

Default baud rate to control the switcher is 115200 and default baud rate to control the display or projector
is 9600.

Note: For the display’s actual baud rate, refer to the owner’s manual

To change the baud rate of the switcher (for switcher control) or the zone output (for display/projector
control), the commands below will be needed

Switcher baud command

CSpara[baudrate,data-length,parity,stop-bit]

(data-length, parity, and stop-bit for switcher must be 8,0,1)

Example: To change the baud rate to 38400 use CSpara[38400,8,0,1]