Atlona ATPROHD1616M SR - Manual (Page 6)

www.atlona.com | toll free: 1-877-536-3976
For International: 1- 408-962-0515
6
Note: For better functionality of the IR, we suggest to place the IR receiver Eye at the IR Eye of the controlling source.
CONNECTION AND OPERATION
1) Connect the HDMI input sources (such as BluRay, PS3, AppleTV, DirecTV etc) into the inputs on
AT-PROHD1616M-SR.
2) Connect the HDMI outputs from AT-PROHD1616M-SR (such as LCD, Plasma, LED, Projector, Monitor)
3) Power on the input source you want to show. (Keep the unused input power OFF, otherwise it may interfere
with the normal display.)
4) Use IR remote, front panel, RS232, TCP/IP or RS485 connections to choose desired input source.
5) IR calls back from remote locations allows controlling the matrix switch as well as nearby sources (such as
BluRay, AppleTV, Satellite, Cable and etc…).
6) Instruction on IR Emitter.
The sequence of “IR1, IR2, IR3, IR4, IR5, IR6, IR7, IR8, etc.” one-to-one correspond with “HDMI Inputs
1~16”. When an output chooses certain input, the call-back IR signal of RJ45 on this output will choose the
corresponding “IR” port to send the signal out.
For example, OUTPUT#1 chooses INPUT#3, then the call-back IR signal of RJ45 on OUTPUT#1 will choose
“IR 3” to send the signal out.
LCD DISPLAY
If the touch screen becomes insensitive, calibration is required
Press the panel button “Setting” in the home menu status, holding until the following prompt appears(about 4s).
Press the symbol’s center, until the one disappears and another symbol appears, and press its
center again until the end of the calibration—OK or Failure. If the calibration failED, please confirm whether the
symbol’s center was aligned, then try again. After calibration is finished, press the panel button “Setting”, holding
until exit the calibration menu (about 4s)