Atlona ATPROHD1616M SR - Manual (Page 12)

www.atlona.com | toll free: 1-877-536-3976
For International: 1- 408-962-0515
12
TX – Connects to the Switch
RX – Connects to the HDMI Receivers
RS232 Control:
Baud Rate: 9600 bps
Data bits: 8 bits
Parity: None
Stop bits: 1 bit
Flow control: None
The AT-PROHD1616M-SR comes with an IR remote control, which could be used to control the switcher when pointing
at it or controlling the switcher from a remote location by pointing the remote control to the IR Eye connected to the HDMI
receiver.
For users who would like to use a 3rd party IR remote control or IR remote system, we recommend either learning IR
codes off the remote or copying and pasting the IR HEX code into the remote control software. The file with HEX codes
could be found on Atlona website under downloads for AT-PROHD1616M-SR.
There are 2 scenarios which codes to use:
• User will need to learn all 32 x codes in order to control each location when pointing at the switcher
• User will only need to learn 16 x codes if there will be a separate remote for each remote location
Note: The switcher can only accept and route IR signal which doesn’t exceed 38 KHz. In other words, if you are trying to
send IR signal from the remote location through HDMI receiver and the IR signal is higher than 38 KHz, the IR signal will
not pass though.
VERY IMPORTANT:
When connecting IR receivers and IR emitters, be very careful as if they are reversed the IR Eye will burn-out
and also may damage the IR module inside of the switch and Receiver.