Applied Motion TXM24C-1CG - Manual

TXM
TXM24C Quick Setup Guide
Requirements
To begin, make sure you have the following equipment:
• A 12-70V DC power supply.
• A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit) and Windows 8.
• Step-Servo Quick Tuner software (available at www.applied-motion.com/products/software).
• A CAN communication cable for connecting to the CAN network.
• For more detailed information, please download and read the TXM24 Hardware Manual, available at www.applied-
motion.com/support/manuals.
Step1- Wiring
Wire the drive to the DC power source.
(Do not apply power until Step 3)
Note - the TXM24 accepts DC voltages from 12-70V. If
using an external fuse, we recommend a 5 amp fast acting
fuse.
(See the TXM24 Hardware Manual for more information
about power supply and fuse selection.)
▪ Connect I/O, if required by your application. A 3004-290-
5M cable will be required.
(See the TXM24 Hardware Manual for more information
about wiring I/O to the TXM24.)
▪ Connect to CAN network.
Applied Motion Products TXM24C drives use a CAN
communication cable 3004-311-5M, that conforms to the
DR303 specification. The cable should be wired in a daisy-
chain configuration with a 120 Ohm resistor used to
terminate each end.
▪ Connect the RS-232 programming cable.
GND
EMI Filter
AC
Power
Input LINE LOAD
L
N N
L
V+
V-
P/N:092.00823.00 (LCR)
4
3
1
2
POWER
DC POWER
SUPPLY V-
V+ V+
V-
GND
920-0093 Rev. A
CAN_BUS
2
3
7
DSUB9
Female
CAN_L
GND
CAN_H
R Termination
120 Ohm nominal
CAN_L
GND
CAN_H
3 2 1
R Termination
120 Ohm nominal
CAN_L
GND
CAN_H
3 2 1