Introduction, Presentation – ABUS Technologies A4000 Series Universal Controller User Manual

Page 4

ABUS TECHNOLOGIES INC.

A4000

1. INTRODUCTION

A4000 series is a Microprocessor based Digital Process Controller, which can

be applied to high-precision measurement and control of temperature, pressure,

discharge, liquid level and humidity etc... A four-digit LCD dual display indicates

measured value and set-value for all programming parameters. Instrument

configuration is achieved from the front panel keyboard, without any hardware change.

The user should read this manual thoroughly before using the instrument. It must be

handled with care and should be used accordingly for best results.

2. PRESENTATION

Technical Parameters

Display:

Range:

-1999 ~ 9999

Setting Mode:

Panel Setting

External Setting

Programmable Curve Setting (Ramp & Soak)

Isolation Output:

 One loop analogue or control output, resolution more than 12 digits.

Current 0-20mA is adjustable, output impedance 600 Ohm. The unit only supplies 4-

20mA and 0-20mA analogue output. If the user requires Voltage, he/she can

connect impedance of 250 Ohm to get voltage 1-5V. (Accuracy depends on the

impedance connected).

 Relay contact switch output: 250V/3A or 30VDC/3A. The main control output can be

selected freely by the user.

SSR pulse voltage output: 24VDC/30mA.

SCR contact output:

Can contact 5-500A SSR.

Sampling Rate:

<0.5S

Control mode:

PID control; Preset curve control; Pulse width control;

Direct electronic machine control etc...

The products can supply two wires isolate power 24V/30mA.

Communication:

RS485 (optional)

Can calibrate Zero & Span and make it more reliable and accurate.

Power:

85-265V AC/DC, consumption: <5VA

Ambient Temperature:

0-50°C