Tascam X-48 - Manual (Page 30)

Configuration
Mouse/Keyboard Operation
•
Open the Windows menu and select Settings
• Click the System tab
• Click the System Settings Store button. Type a name for the settings and click OK.
• To restore the system settings you've saved, click the Recall button and find your
backup.
Front Panel Operation
• Press
the SYS button
• Press the Up/Down buttons until you select Settings and press CHNG.
• Select Store... using the Up/Down buttons and pres CHNG.
• Give your settings a name using the Up/Down buttons and the CHNG button to
cursor forward, then press ENTER/YES.
• To recall your settings, select Recall... from the previous menu and locate your
backup file.
Mixer Bypass
Bypassing the mixer section improves inupt to output delay and and reduces CPU usage by
keeping the mixer EQ, level, etc. settings disabled when using the X-48 strictly as a
recorder. Mixer Bypass is switched on by default, so you'll need to disable it before using
the mixer section. To access this setting:
Mouse/Keyboard Operation (only)
•
Open the Windows menu and select Settings
• Select the System tab
• Check or uncheck the Mixer Bypass checkbox.
Make a Default Project
You can define a default project which has all of the routing and sync presets you typically
use. To do this:
Mouse/Keyboard Operation (only)
•
Open the File menu and select Save Project As...
• Navigate to D:\XProjects\Startup\
• Name your project "Startup". Click OK to replace the old file.
Install VST Plug-Ins
See Chapter 'Mixing' for information on using Third-Party Plug-Ins.
30