MIPRO ma101act(2ce132) - Manual (Page 5)

Rechargeable Multi-Function Wireless Microphone
(6) Power indicator: It indicates status of batteries. The moment
when the microphone switches on, indicator will flash once
showing the battery status is normal. When indicator is not
flashing, it means the battery is out or not being installed
properly. If the indicator flashes continuously, it indicates wrong
frequency band and please check if transmitter's frequency band
matches amplifier's. If the indicator does not go off after
switching on, it indicates the battery level is low and battery
requires immediate charge.
(7) Power switch: To use, make sure the switch is at "ON" position
and "OFF" position when not in use.
(8) MIC/LINE switch: When using LINE IN or an electric guitar, make
sure the switch is at "LINE" position. When connecting to a
condenser microphone or cable microphone, the switch should
be at "MIC" position.
allows users to adjust input
sensitivity at either MIC or LINE position.
(9) Volume control: To adjust input volume.
Volume control
(1) Grille and capsule module: To eliminate "POP" noise and protect
the capsule module that converts voice into audio signal.
(2) ACT button: To turn on/off the amplifier and setup microphone
frequency to match amplifier's receiving frequency.
(3) ACT indicator: When press ACT button (2), ACT indicator (3)
turns into red. The ACT indicator will go out after 3 seconds
then ACT button (2) can be activated again.
(4) Hanger: To couple with any external stripe with hook so that
users can wear the microphone in front of their chests.
(5) Charging spring: For external charging purpose.
- 7 - - 8 -
1. Functions of Each Part:
Front & Rear View：
Side View：
(1) (2) (3)
(4) (5)
(6) (7)
(8) (9)