MIPRO ma101act(2ce132) - Manual (Page 2)

Thanks for choosing MIPRO's wireless remote amplifier. Careful
and thorough reading of this instruction before using will assist you to
understand correct operating of the system and obtain the most optima
performance of the system.
MA-101ACT wireless remote amplifier equips with the most
innovative designs that delivers clear sound and powerful volume. Its
user-friendly design and inexpensive price make MA-101ACT the best
amplifier system in educational institutes or similar facilities where
lectures or lessons are given. It features compact speaker cabinet, built-
in 30 watts (RMS) high-efficiency amplifier, high-sensitivity full-range
speaker, detachable AC switching power supply and it is wall-mountable.
When the amplifiers are under the same carrier frequency band, no
matter which receiving channel the amplifier has, each transmitter can
remote-control amplifier's power and volume. Furthermore, other than
holding the transmitter in hands, an external lavaliere microphone,
headset microphone or other audio sources can also connect to the
transmitter. The transmitter has built-in rechargeable batteries that allow
users simply put the transmitter back to designated charger after use.
Built-in rechargeable battery simply saves you money to buy batteries
and saves you troubles to replace batteries.
- 1 - - 2 -
(5)
(2)
(1)
(3)
(4)
(1) Main body: the speaker cabinet.
(2) Infrared receptor and transmitter: To receive power-on signal and
transmit frequency information to transmitter.
(3) Power indicator: Red LED indicates the power is on and green
LED indicates the system receives signals from the transmitter.
(4) Speaker: 5-inch full range speaker.
(6)
(7)
(8)
(9)
(7)
(5) External speaker connector: For connect to a 4~16 external
speaker.
(6) Receiver module: Swappable receiver module with different
frequency band.
(7) Hanger trough: For hanging the system on the wall with any
nails or hooks in upright or upside-down.
(8) 18V DC input jack: The center pole is positive voltage and
consumption current must be at least 2.5 A.
(9) Switching power supply holder: Holder pin must be released
before changing the power supply.
(10) Switching power supply: Input 90V~264V AC, Output 18 Volt /
2.5 A DC.
(11) Wall-mounting rack fixed screw hole: Special adjustable hanging
rack can be fixed to the cabinet.
Ω
(11)
(10)
1. Functions of Each Part:
Front Panel：
Rear Panel：
Wireless Remote-Controlled Lecture Amplifier