MIPRO ma101act(2ce132) User Manual

Page 3

- 3 -

(1) To turn on wireless amplifier:

(a) Point the bottom of transmitter to the front of amplifier and press

the ACT button located on the transmitter. Hold the transmitter
steady for about 3 seconds where the amplifier power indicator's
(3) red LED will light up. If the red LED remains light up after
more than 3 seconds, the amplifier power-on is complete.
However, if the red LED light goes out after 3 seconds, the
power-on process is not completed and repeats above sequence.

(b) Turn on the transmitter power switch (3) and power indicator LED

(3) on the amplifier will turn green. It indicates the amplifier
receiving signals from the transmitter and ready for use.

level by following the directions indicate on the volume control.

(a) Operating angel is about 30-degree radius (top to bottom).

(b) Operating distance range of infrared is around 10 meters.

microphone steady for at least one second before moving
transmitter away.

(d) When ACT button (2) on the transmitter is pressed, the LED (3)

on the right of the button will light up for about 3 second. ACT
button will not work again until LED goes out.

(2) Allowing the transmitter to work at any frequency under the same

frequency band is MIPRO's unique innovative feature. If transmitter
and receiver are under different frequency band, power indicator on
the transmitter flashes. When the indicator flashes, please check if
receiver and transmitter are under the same frequency band.

(3) Use of external audio sources: Connecting an output signal from CD

or cassette player to the 3.5

input jack on the transmitter top end

for wireless transmission. Make sure MIC/LINE switch is at LINE
position. Volume of amplifier is properly adjusted by the volume
control on the transmitter. However, if the sound occurs overloaded
distortion, please lower the output level on the CD or cassette player.

(4) When the transmitter aims at the amplifier and push the ACT button

(2) on the transmitter, if LED indicator (3) on the amplifier turn on red
and diminish , it is very possible that the transmitter is running low
on power and unable to transmit RF signal. If the batteries are
totally drained, then the ACT button will not function at all.

(2) To turn off wireless amplifier:

- 4 -

(1) Operation of Infrared Control:

30°

3. Special Notes:

2. Operating:

Point the bottom of transmitter to the front of amplifier and press

the ACT button located on the transmitter. The amplifier power
indicator's (3) red light will go out.