SoundMax SM-CDM1030 - Manual (Page 11)

11
Function of controls
General operations
Reset the unit
Operating the unit for the first time or after replacing the car battery, you must reset the unit.
Press OPEN button and remove the panel, then press the RESET button to restore the unit to the original
factory settings.
Power button
Press the POWER/MOD button on the front panel or POWER button on the RC to switch the unit on.
Press the POWER/MOD button on the front panel or POWER button on the RC to switch the unit off.
Note: After the unit is off, the clock, volume level and radio current settings will be memorized, and when
you turn the unit on it will resume the stored status which you set.
Volume mode
Rotate VOL knob clockwise to increase the volume level; rotate anticlockwise to decrease the volume level.
Or press VOL +/- buttons on the RC
Press SEL button (VOL knob) on the front panel shortly and repeatedly to select the mode: TIME => VOL =>
BAS => TRE => BAL => FAD => LOU => LOC. Rotate the VOL knob or use VOL +/- buttons to adjust each
mode.
- VOLUME: 00, 02,......, 44, 46
- BASS/TREBLE: -6, -5,......, 0, +1, +2,......+5, +6
- BALANCE: 12L, 11L,......, L=R, 1R,......,12R
- FADER: 12R, 11R,......, R=F, 1F,......, 12F
- LOUD mode: rotate the VOL knob to select: LOUD ON or LOUD OFF
- LOC mode: select the local radio broadcasting by rotating the VOL knob: LOC ON => LOC OFF
NOTE: Adjustments to Bass and Treble will override any preset EQ (Preset Equalizer Curves).
In each mode, the waiting time is about 5 seconds, and the waiting time is over, it returns to the last display
mode of radio or disc playback mode.