Optoma HQView320 - Manual (Page 8)

© Calibre UK Limited Issue 2.40 22
nd
April 2013
4
HQVIEW-3XX SYSTEM DESCRIPTION
2.1. Product Overview
HQView-3xx is designed to accept the following input signals:

YPbPr or RGBS SD/ED/HD component video via 3 or 4 BNC connectors

VGA analog (computer interface) via 15HDD

DVI (Digital Visual Interface) via DVI-I (only the digital part is implemented on this connector), HDMI
is supported via a HDMI/DVI adapter.
2.2. Product Specification
This section provides technical details for all possible inputs.
Please note that not all possible input options may be applicable to certain output modes.
2.2.1.
Power Supply Requirement
12V DC table top power supply requiring a 100V-264VAC 50/60Hz mains connection.
2.2.2. Component Video Inputs
Via 3 or 4 BNC connectors
YPbPr, YPbPrS, RGsB and RGBS component video, menu selectable.
Signal formats 484i (480i) and 576i (SD), 480p, 576p (ED), 720p, 1080i at 50, 59.94 and 60Hz and
1080p at 24, 25, 29.97 and 30Hz.
Please note this input does not support Computer SVGA signals which should be connected via the
Computer SVGA input.
2.2.3. Computer (SVGA) Inputs VESA formats
Signal formats: DOS, VGA – WUXGA up to 165MHz pixel clock
RGB video level 0.7V - 1.0V
RGB input impedance 75 Ohms
Sync format Separate H & V sync at TTL/5V levels.
2.2.4. HDMI & DVI Inputs
DVI-D input with or without HDCP
HDMI 1.3 with or without HDCP through a DVI/HDMI adapter, 36-bit video compatible.
HDCP compatibility can be turned off for use with MAC computers.
Signal formats -video
484i and 576i (SD) in double-rate formats (1440 pixels per line), 480p, 576p (ED), 720p, 1080i at 50,
59.94 & 60Hz, 1080p at 24, 25, 30, 50, 59.94 & 60Hz.
Signal formats – computer
DOS, VGA – WUXGA up to 165MHz pixel clock