Optoma Geo Module BE-BWM01 User Manual
Page 9
21. Once you are happy with the grid alignment, click the "Apply All" button to enable
the blend.
22. After this, we highly recommend saving your project, so that you can easily load it
again later. Click the save button and type a filename for your project (Including the
resolution/crop settings in the filename can save a lot of time searching later)
Hints / Troubleshooting:
Seeing as the Geo module uses the on-board scaling of the projector,
it is essential
that the source device provides the same resolution to the projector at all times
.
Switching inputs or resolution will reset the scaling and you will need to re-upload
your project to the Geo boards using the Optoma Blending Tool via a LAN
connection.
Be careful not to press the “reset” button in the main window accidentally – this will
reset all of your GEO modules to their factory default settings… Including resetting
“PC Mode” to OFF. However, if you do this by accident you can easily re-enable PC-
mode in the projectors OSD using the keypad, remote, or via the Crestron
web interface.