Optoma Geo Module BE-BWM01 - Manual

Optoma ProScene Geo Module BE-BWM01 – Setup Guide
“How to do a 2 projector blend on a flat surface using 4-corner correction”
Welcome to this step-by-step guide on how to use the optional Geo Module BE-BWM01 for
edge blending two Optoma ProScene EX855/EW865 projectors. (More projectors can be
added to your project, however the same principles apply but with a few settings being
altered along the way)
This guide assumes that the GEO boards are already installed into your projectors and that
they are running firmware version C18 to support the GEO features. This can be checked
using the Information panel accessible from the projector’s on-screen-display (OSD) menu.
NB: After following these instructions, be sure to read the hints at the end to ensure
consistent, reliable performance from your setup long-term.
1. Download & Install the free "Optoma Blending Tool" software:
(Available from www.optoma.com it can be found in the download section of the
relevant projector products)
2. Connect your equipment as shown below: