NISSAN 2009 Murano - Manual (Page 415)

Black plate (417,1)
Model "Z51-D" EDITED: 2007/ 10/ 2
STI0564
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
. License plate bracket
. Bolt 6 2
. Screw 6 2
. Screw grommet 6 2
1. Park the vehicle on flat, level ground.
2. Line up the tabs
*
B on the license plate
bracket under the top of the front bumper
*
A . Hold the license plate bracket in place.
3. Mark the center of the hole
*
C with a felt-
tip pen.
4. Carefully drill two pilot holes using a 0.39 in
(10 mm) drill bit at the marked locations. (Be
sure that the drill only goes through the
bumper fascia.)
5. Insert grommets into the hole on the fascia.
6. Install the license plate bracket with bolts.
7. Install the license plate with screws.
INSTALLING FRONT LICENSE PLATE
Technical and consumer information 9-11