NISSAN 2009 Murano User Manual

Page 209

Black plate (207,1)

Model "Z51-D" EDITED: 2007/ 10/ 2

ON·OFF/Volume control:

Push the ignition switch to the ACC or ON
position, and then push the ON·OFF/VOLUME
control knob while the system is off to call up the
mode (radio, CD or AUX) which was playing
immediately before the system was turned off.
While the system is on, pushing the ON·OFF/
VOLUME control knob turns the system off.

Turn the ON·OFF/VOLUME control knob to
adjust the volume.

Adjusting tone quality and speaker bal-
ance:

To adjust Bass, Treble, Balance and Fade, push
the Audio control knob. When the display shows
the setting you want to change (Bass, Treble,
Balance and Fade), rotate the Audio control
knob to set the desired setting. For the other
setting methods, see “HOW TO USE SETTING
BUTTON” earlier in this section.

This vehicle has some sound effect functions as
follows (if so equipped):

. Speed Sensitive Volume

For more details, see “VEHICLE INFORMATION
AND SETTINGS” earlier in this section.

Switching the display (for models with
navigation system):

Pushing the DISC·AUX button will switch the

displays as follows:

? CompactFlash* ? DVD* ? AUX ?

iPod

? Music Box* ? CD

*: if so equipped

FM-AM-SAT radio operation

radio (FM/AM) band select:

Pushing the radio band select button will
change the band as follows:

? FM1 ? FM2 ? AM

radio (SAT) band select:

Pushing the radio band select button will
change the band as follows:

(With navigation system)

SAT1

? SAT2 ? SAT1

(Without navigation system)

AUX

? SAT1 ? SAT2 ? AUX

When the radio band select button is pushed
while the ignition switch is in the ACC or ON
position, the radio will come on at the station last
played.

The last station/channel played will also come
on when the ON·OFF/VOL control knob is

pushed to ON.

The satellite radio mode requires an active XM

satellite radio service subscription. Satellite
radio is not available in Alaska, Hawaii and
Guam.

If another audio source is playing when the radio
band select button is turned to ON, the audio
source will automatically be turned off and the
last radio station played will come on.

When the stereo broadcast signal is weak, the
radio will automatically change from stereo to
monaural reception.

TUNE (Tuning):

. For AM and FM radio

Turn the TUNE/FOLDER knob for manual
tuning.

. For XM satellite radio

Turn the TUNE/FOLDER knob to seek
channels from all of the categories when
any CAT is not selected.

SEEK tuning/CATEGORY
(CAT):

. For AM and FM radio

Push the SEEK·CAT or TRACK button
or

to tune from low to high or high to

Monitor, heater, air conditioner, audio, phone and voice recognition systems

4-45