beautypg.com

Getting started -122, Getting started, Choosing a language – NISSAN 2010 Maxima User Manual

Page 282: Pairing procedure

background image

You can also use the

button

to interrupt the system feedback
and give a command at once. See
“List of voice commands” and
“During a call” in this section for
more information.

PHONE/END
While the voice recognition sys-
tem is active, press and hold
the

button for 5 seconds to

quit the voice recognition system
at any time.

TUNING SWITCH
While using the voice recognition
system, tilt the tuning switch up or
down to manually control the
phone system (if so equipped).

GETTING STARTED

The following procedures will help you get

started using the Bluetooth

ா Hands-Free Phone

System with NISSAN Voice Recognition. For ad-

ditional command options, refer to “List of voice

commands” in this section.

Choosing a language

You can interact with the Bluetooth

ா Hands-Free

Phone System using English, Spanish or French.
To change the language, perform the following.

1. Press and hold the

button for more

than 5 seconds.

2. The system announces: “Press the

PHONE/SEND (

) button for the

hands-free phone system to enter the

speaker adaptation mode or press the
PHONE/END (

) button to select a dif-

ferent language.”

3. Press the

button.

For information on speaker adaptation, see

“Speaker adaptation (SA) mode” in this sec-

tion.

4. The system announces the current language

and gives you the option to change the lan-

guage to Spanish (in Spanish) or French (in

French). Use the following chart to select

the language.

NOTE:

You must press the

button or

the

button within 5 seconds to

change the language.

Current

language

Press

(PHONE/SEND)

to select

Press

(PHONE/END) to

select

English

Spanish

French

Spanish

English

French

French

English

Spanish

5. If you decide not to change the language, do

not press either button. After 5 seconds, the

VR session will end, and the language will

not be changed.

For color monitor system language change, see

“Language/Units” in this section.

Pairing procedure

NOTE:
The pairing procedure must be performed

when the vehicle is stationary. If the vehicle

starts moving during the procedure, the

procedure will be cancelled.

4-122

Monitor, climate, audio, phone and voice recognition systems