NISSAN 2010 Maxima - Manual (Page 252)

iPod ா* PLAYER OPERATION
WITHOUT NAVIGATION SYSTEM (if
so equipped)
Connecting iPod
ா
To connect an iPod ா to the vehicle so that the
iPod ா can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Open the protec-
tive cover
᭺
1 on the USB jack in the center
console. Then connect the iPod ா-specific end of
the cable to the iPod ா and the USB end of the
cable to the USB jack on the vehicle. When the
ignition switch is in the ACC or ON position, the
battery of your iPod ா (if compatible) is charged
during the connection to the vehicle.
While connected to the vehicle, the iPod
ா can
only be operated by the vehicle audio controls.
To disconnect the iPod
ா from the vehicle, remove
the USB end of the cable from the USB jack on
the vehicle, then remove the cable from the
iPod ா.
* iPod ா is a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are available:
● iPodா Classic - 1st through 6th generation
● iPodா Mini - 1st and 2nd generation
● iPodா Nano - 1st through 3rd generation
● iPodா Touch - 1st generation
● iPhoneா - 1st generation
Make sure that your iPod ா firmware is updated.
Audio main operation
Place the ignition switch in the ACC or ON
position. Press the AUX button repeatedly to
switch to the iPod ா mode.
If the system has been turned off while the iPod ா
was playing, pressing the VOL/ON·OFF control
knob will start the iPod ா.
AUX button:
When the AUX button is pressed with the system
off and the iPod ா connected, the system will turn
on. If another audio source is playing and the
iPod ா is connected, press the AUX button re-
peatedly until the center display changes to the
iPod ா mode.
WHA1366 LHA1395
4-92 Monitor, climate, audio, phone and voice recognition systems