beautypg.com

Climate control seat switch (if so equipped) -34 – NISSAN 2010 Maxima User Manual

Page 106

background image

The climate controlled seat warms up or cools

down the front seat by blowing warm or cool air

from the surface of the seat. The climate control

switch is located on the center console.
The climate controlled seat can be operated as

follows:

1. Start the engine.
2. Turn the control knob to the H (Heat) side or

to the C (Cool) side, as desired. The indica-

tor light on the control knob will illuminate.

3. Adjust the desired amount of air using the

control knob. The climate controlled seat

blower remains on low speed for approxi-

mately 60 seconds after turning the switch

on or selecting the desired temperature.

4. When the vehicle’s interior is warmed or

cooled, or before you leave the vehicle, be

sure to turn the control knob to the Off

(center) position

To check the air filter for the climate controlled

seat, contact a NISSAN dealer.

CAUTION

The battery could run down if the cli-

mate control seat is operated while the

engine is not running.

Do not use the climate control seat for

extended periods or when no one is

using the seat.

Do not put anything on the seat which

insulates heat, such as a blanket, cush-

ion, seat cover, etc. Otherwise, the seat

may become overheated.

Do not place anything hard or heavy on

the seat or pierce it with a pin or similar

objects. This may result in damage to

the climate controlled seat.

Any liquid spilled on the seat should be

removed immediately with a dry cloth

The climate controlled seat has an air

filter. Do not operate the climate con-

trolled seat without an air filter. This

may result in damage to the system.

When cleaning the seat, never use

gasoline, benzine, thinner, or any simi-

lar materials.

If any malfunctions are found or the

climate controlled seat does not oper-

ate, turn the switch off and have the

system checked by your NISSAN dealer.

LIC1410

CLIMATE CONTROL SEAT SWITCH (if

so equipped)

2-34

Instruments and controls