Subaru 2002 Impreza - Manual (Page 97)

IMPREZA(NA) A1830BE-A (ENGLISH)
Keys and doors
2-12
operates by operating each transmitter.
B Deleting old transmitter codes
The control unit of the keyless entry system has four
memory locations to store transmitter codes, giving
it the ability to operate with up to four transmitters.
When you lose a transmitter, the lost transmitter’s
code remains in the memory. For security reasons,
lost transmitter codes should be deleted from the
memory.
To delete old transmitter codes, program four trans-
mitter codes into the system. If you have only one
current transmitter, program it four times. If you have
two current transmitters, program each one twice. If
you have three current transmitters, program two of
them once and the third one twice. This process will
leave only current transmitter codes in the system’s
memory.
NOTE
Make sure no one else is operating their keyless
entry system within range of your vehicle when
programming transmitters. If someone else were
to operate their remote transmitter while you are
programming your transmitters, it is possible
that their transmitter code will be programmed
into your system, allowing them unauthorized
access to your vehicle.
Security system (if equipped)
The security system helps to protect your vehicle
and valuables from theft. The horn sounds and the
parking lights flash if someone attempts to break
into your vehicle. The starter motor is also inter-
rupted to prevent starting the vehicle without a key.
The system can be armed and disarmed with the
remote transmitter.
The system does not operate when the key is in-
serted into the ignition switch.
J System operation
The security system will give the following alarm in-
dications when triggered:
D The parking lights will flash and the horn will
sound intermittently. In addition, the starter motor will
not operate.
D The alarm automatically resets after 30 seconds;
however, the alarm will reactivate if the vehicle is
tampered with again. The alarm will continue for six
times if any sensor continues to be activated.
The alarm is triggered by:
D Opening a door, the rear gate or trunk lid.
D Application of physical shock to the vehicle (e.g.