Subaru 2002 Impreza - Manual (Page 164)

IMPREZA(NA) A1830BE-A (ENGLISH)
5
Audio
5-7
– CONTINUED –
FM1 FM2 AM
The display indicates which one is currently
selected.
B Stereo indicator
The stereo indicator “ST” will come on when an FM
stereo broadcast is received.
B Manual tuning (TUNE)
Push the tuning button (3) marked “
∧
” to increase
the tuning frequency and press the tuning button
marked “
∨
” to decrease it.
Each time the button is pressed, the frequency
changes 10 KHz in the AM waveband and 0.2 MHz
in the FM waveband.
Constant pressure on the button causes a continu-
ous change in the frequency.
B Automatic tuning (SCAN)
Press the “SCAN” button (1) to change the radio to
the SCAN mode. In this mode, the radio scans
through the radio band until a station is found. The
radio will stop at the station for five seconds while
displaying the frequency, after which scanning will
continue until the entire band has been scanned
from the low end to the high end.
Press the “SCAN” button again to cancel the SCAN
mode and to stop on any displayed frequency.
When the “SCAN” button is pressed for automatic
tuning, stations are scanned in the direction of low
frequencies to high frequencies only.
Automatic tuning may not function properly if the sta-
tion reception is weakened by distance from the sta-
tion or proximity to tall buildings and hills.
B Selecting preset stations
Presetting a station with a preset button (5) allows
you to select that station in a single operation. Up to
six AM, FM1 and FM2 stations each may be preset.
B How to preset stations
1. Press the “FM/AM” selection button to select AM,
FM1 or FM2 reception.
2. Press the “SCAN” button (1) or tune the radio
manually until the desired station frequency is dis-
played.
3. Press one of the preset buttons (5) for at least 2
seconds to store the frequency. The frequency of
the station will flash once on the display at this time.
If the button is pressed for less than 2 seconds, the
preceding selection will remain in memory.