Mercedes-Benz 2013 CLA Class - Manual (Page 111)

Headlamp range control
g
Driver's seat and front-passenger seat
occupied
1
Driver's seat, front-passenger seat and
rear seats occupied
2
Driver's seat, front-passenger seat and
rear seats occupied, luggage compart-
ment laden
3
Driver's and front-passenger seats occu-
pied and maximum permissible rear axle
load utilised, e.g. when towing a trailer
X Start the engine.
X Turn the headlamp range control to the
position which corresponds to the load in
your vehicle.
Combination switch
Turn signals
:
Main-beam headlamps
;
Turn signal, right
=
Headlamp flasher
?
Turn signal, left
X To indicate briefly: press the combination
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
X To indicate: press the combination switch
beyond the pressure point in the direction
of arrow ; or ?.
Main-beam headlamps
X To switch on the main-beam head-
lamps: turn the key in the ignition lock to
position 2 or start the engine.
X Turn the light switch to L or Ã.
X Press the combination switch beyond the
pressure point in the direction of
arrow :.
In the à position, the main-beam head-
lamps are only switched on when it is dark
and the engine is running.
The blue K indicator lamp in the instru-
ment cluster lights up when the main-beam
headlamps are switched on.
X To switch off the main-beam head-
lamps: move the combination switch back
to its normal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
i Vehicles with Adaptive Highbeam Assist:
when Adaptive Highbeam Assist is active,
it controls activation of the main-beam
headlamps (
Y page 111).
Headlamp flasher
X To switch on: turn the key in the ignition
lock to position 1 or 2, or start the engine.
X Pull the combination switch in the direction
of arrow =.
Exterior lighting
109
Lights and windscreen wipers
Z