Lenco SB-210BT - Manual (Page 13)

GB-13
 Leave 5 cm (2”) free space around the device.
 Always make sure the device is well ventilated.
 Keep the device away from heat sources such as radiators, heaters, stoves,
candles and other heat-generating products
 Avoid using the device near strong magnetic fields.
 Do not use this device when condensation may occur.
 Do not use this device near water or other liquids.
 Do not use this device in a damp room.
 Do not use this device near a swimming pool.
 Electrostatic interference may interfere with the normal use of this device. If
this occurs, reset the device and restart it according to the instructions in the
user manual.
 The display is made of plastic and might break when it’s damaged. Beware
of sharp plastic splinters when the screen breaks to avoid injury.
 Should the unit become wet, immediately remove the plug from the power
outlet and let the appliance fry for 72 hours before trying to use it again.
 Remove the batteries from the device and/or remote control if they will not be
used for a long time.
 This device and the supplied accessories contain sensitive components.
Never drop them, put them in a microwave, burn them or paint them.
 Do not bite or suck on the device and/or supplied accessories.
 Do not insert the device or the supplied accessories in your ears, mouth or
other body orifices.
 This device and/or accessories contain small parts that may lead to a
choking hazard. Therefore, keep it away from children.
 When connecting the device, if a connector does not seem to fit, do not force
it.
 Be careful when using this device when participating in traffic, the sound
might distract your attention.
 Lenco recommends using A-brand batteries.
WARNING: Prolonged exposure to loud sounds from personal music
players may lead to temporary or permanent hearing loss.
WARNING: Do not use a USB extension cable to connect a USB
device. The use of a USB extension cable can cause malfunction or
loss of data.
Declaration of Conformity
Products with a CE marking comply with the EMC directive
(2004/108/EC) and the Low Voltage Directive (2006/95/EC) issued by
the European Commission of the European Community.
RoHS, this device has been manufactured according to the RoHS Directive.
ErP II, this device complies with the ErP Directive.
WEEE, this device complies with the 2002/96/EC Directive.