beautypg.com

Safety instructions – Lenco SB-210BT User Manual

Page 12

background image

GB-12

Safety instructions

Explanation of symbols:

This symbol indicates that there are important operating maintenance

instructions in the user manual accompanying the device.

This symbol indicates that dangerous voltage is present within this

device, constituting a risk of electronic shock or personal injury.

CAREFULLY READ THE FOLLOWING SAFETY INSTRUCTIONS BEFORE

USE.

WARNING

RISK OF ELECTRIC SHOCK

DO NOT OPEN THIS DEVICE

WARNING: DO NOT REMOVE ANY SCREWS OR OTHER

COMPONENTS OF THE DEVICE TO PREVENT THE RISK OF

ELECTRIC SHOCK.

Install and use the device only as described in the user manual.

This device must be used in combination with a power supply as specified in

the specification table. If you are not sure of the type of power supply used in

your home, consult your power company.

Do not use loose or damaged cords and/or plugs.

This device has a Class II construction. Devices with a Class II construction

can be connected to an unearthed power outlet.

The power outlet must be located close the device and must be easily

accessible.

Make sure that power outlets or extension cables are not over overloaded.

Overloading can cause short-circuits or fire.

Always pull the plug when removing it from the power outlet.

Do not pull the power cord. This may cause a short-circuit.

If you notice smoke, an excessive build-up of heat or any other unexpected

phenomena, you should disconnect the plug from the power outlet

immediately.

Disconnect the plug from the power outlet during lightning storms.

Disconnect the plug from the outlet when the device will not be used for a

long time.

Do not step on the power cord and don’t pinch the power cord.

Do not place heavy objects on the power cord or any other cables as this

may damage the cord or cables.

Keep the device away from children! When they play with the power cord,

they can seriously injure themselves.

Keep the power cable away from rodents and rabbits.

Make sure all ventilation openings are clear at all times, do not cover or block

them.