Lenco IR-3000 - Manual (Page 7)

3. Press the SELECT button.
4. Press Tune up or down until the display says.
5. Press the SELECT button. Rotate the dial until the display says.
6. Press the SELECT button
7. Rotate the dial until the hour setting is correct, then press the SELECT button.
8. Rotate the dial until the minute setting is correct, then press the SELECT button.
The display will then read “Time Set” with the new time shown beneath for 3 seconds, then the
system returns to the radio station display.
Setting the ‘Sleep Timer’
Note: If you make a mistake at any point, press BACK button to go back to the previous screen
1. Press the Back button.
2. Rotate the dial until the display says.
3. Press the SELECT button.
4. Rotate the dial until the display says.
- 6 -
< Clock >
< Set time >
Set time
00:00
Set time
05:08
Set time
05:12
Configure