Lenco IR-3000 - Manual (Page 4)

(7) Press the SELECT button;
(8) Rotate the dial to select the option that best describes your set up (Auto, Wired Only, Wireless
Only).
If you select Auto, the system will automatically detect your settings.
If you select Wired Only, it will only connect via Wired Ethernet. You should make sure the Wired
Ethernet lead is plugged into the RJ45 socket.
Note: There are 2 LEDs in the RJ45 Wired Ethernet socket (green for the network link, orange
indicates network traffic);
If you select Wireless Only, the radio will connect using a Wi-Fi connection.
With a wi-fi connection, the system will search for all available networks. When the wireless
network name (ESSID) for the access point you want to connect to is displayed on the screen,
press the SELECT button. You may need to enter the correct WEP (Wired Equivalent Privacy) or
WPA (Wi-Fi Protected Access) code depending on your network security settings.
If your network is not configured to request a WEP or a WPA code, the following display will
show:
Then the network is using one of the encryption systems:
WEP or WPA. You therefore need to enter the correct WEP or WPA code into the radio for it to
communicate with your network.
After 3 seconds the display will go into the code entry mode, if not, press SELECT.
To enter the code, rotate the dial to select each character of the code in turn, pressing the
SELECT button after each character.
WEP and WPA codes are case sensitive to upper and lower case characters so you must enter
them exactly as provided.
After the final character, rotate the dial to select END and press the SELECT key.
The display shows “Connecting to WiFi” as the radio connects to the network:
- 3 -
Auto
Wired Only
Wired/Wireless
Connecting to
WiFi
<{}~ END < >0
Connecting to
WiFi