Lenco IR-3000 - Manual (Page 3)

SETTING UP
Please follow these steps to connect the radio to your network.
Step 1- Switching on the radio:
Plug the AC power lead into the socket at the back of the radio (17) then switch on at the main
switch to power-on the unit.
Caution: Connecting a power supply with a different rating will cause permanent damage to the
radio and may be hazardous.
The display on the front of the radio will light up and say:
Followed by:
Note: The receiver will start in whatever mode it was last used in (Internet Radio/Media Player).
After a few seconds, this will change to show:
Step 2- Connect to network connection:
Note: If you make a mistake at any point, press the BACK button to go back to the
previous screen.
(1) Press the SELECT button;
(2) Rotate the dial until the display says “Configure”;
(3) Press the SELECT button;
(4) Rotate the dial until the display says “Network Config”;
(5) Press the SELECT button;
(6) Rotate the dial until the display says “Wired/Wireless”;
- 2 -
Network Config
Configure
Connecting to
SSID
Initializing
Network
Reciva Enabled
ARM Powered