Troubleshooting – Nexen MB600 801305 User Manual
Page 8
5
FORM NO. L-20124-G-0210
TROUBLESHOOTING
Compression
Spring
Hub
Sleeve
Bearing
Housing
Torque
Plate
Pressure Plate
Drive Disc
O-ring
Seal
Piston
Cylinder
FIGURE 4
Friction Facings
Symptom
Probable Cause
Solution
Failure to Engage
Broken Compression Springs
Replace the Compression Springs.
Worn Friction Facings
Replace the Friction Facings.
Failure to Disengage
Air leaks around the O-ring Seal Replace the O-ring Seal.
Low air pressure
Check air line for leaks and replace air line if necessary.
Minimum Motor Brake release air pressure is 65 psi.
This manual is related to the following products: