Volvo 2005 C70 - Manual (Page 97)

91
Installing the wheel
Clean the contact surfaces on the wheel and
hub. Lift the wheel and place it on the hub.
Make sure that you align the wheel with the
guide stud on the wheel hub prior to
installation. Install the wheel bolts crosswise
(see illustration) and tighten by turning lightly
clockwise. Lower the vehicle to the ground
and alternately tighten the bolts to 100 ft. lbs.
(136 Nm). Install the wheel cap (where
applicable).
CAUTION: Correct tightening torque on
wheel bolts must be observed. The wheel
bolts should never be greased or lubricated.
The extended, chromed wheel bolts must
not be used with steel rims, as they make it
impossible to fit the hub caps.
Correct tightening order for wheel bolts
WARNING!
• The jack’s attachment must engage the
bar in the jack attachment (see inset
illustration in center column on the
previous page). The car’s weight must
not rest on the jack attachment.
• Be sure the jack is on a firm, level,
non-slippery surface.
• Never allow any part of your body to
be extended under a car supported by
a jack.
• Use the jack intended for the car when
replacing a wheel. For any other job,
use stands to support the side of the
car being worked on.
• Apply the parking brake, select
position P (automatic transmission) or
Reverse gear (manual transmission).
• Block the wheels standing on the
ground, use rigid wooden blocks or
large stones.
• The jack should be kept well-greased.
Wheels and tires