Volvo 2005 C70 - Manual (Page 53)

47
Front seats
Electrically operated seats with memory function
1 Lumbar support
2 Strap for controlling front seat for rear seat passengers
3 Backrest release control lever
4 Power seat control panel
Programming the seat's memory
Three seat positions can be programmed using the memory
function. To program a seat position:
1 Adjust the seat to the desired position.
2 Depress the MEM button.
3 Press button 1 to program the current position of the seat.
Buttons 2 and 3 can be programmed in the same way.
Moving the seat to a programmed position
• Depress button 1, 2 or 3 until the seat stops in the programmed
position.
• If the button is released before the seat has reached the pro-
grammed position, the seat will stop as a safety precaution.
NOTE: The seat has an overload protector which engages if an
object blocks the movement of the seat. If this happens, remove the
object and wait 20 seconds before operating the seat again.
Movement of the seat can be STOPPED at any time by pressing
any button on the power seat control panel.
Power seat control panel
A - seat front (raise/lower), B - forward/rearward,
C - seat rear (raise/lower), D - backrest tilt
WARNING!
The power seats are operable with the ignition OFF. Therefore, children
should never be left unattended in the car.
• Do not adjust the seat while driving. The seat should be adjusted so that
the brake pedal can be depressed fully. In addition, position the seat as
far rearward as comfort and control allow. The seat rails on the floor
must not be obstructed in any way when the seat is moved.
• Make sure the seats are securely locked in position after they have been
adjusted.
Memory programming buttons
8501635A
4
3
2
1