G-Shock GW-1310RCJ-3AJR - Manual (Page 8)

Operation Guide 3346
8
10.
When all of the settings are the way you want, press the
A A A A A button.
• This exits the setting screen.
• The display also will exit the setting screen automatically if
you do not perform any operation for about two or three
minutes.
Digital-Analog Synchronization
After adjustment of the digital time, the watch automatically
adjusts its analog setting to match.
• When adjusting the analog time, the hands move clockwise.
• Depending on how many hours different the digital and analog
time settings are, it may take some time for the analog hand
setting procedure to be finished.
Adjusting the Analog Time Setting
You can use the Hand Setting Mode to manually adjust the analog
time when it does not match the digital time.
1.
In the Hand Setting Mode,
hold down the
A A A A A button
for about one second.
• This will cause the hour and
minute setting of the digital
time to flash on the display.
2.
Use the D D D D D (+) button to
adjust the hour and
minute hands so they
match the digital time.
• Each press of the D button
moves the hands 20 seconds
clockwise.
• Holding down the D button
moves the hands at high
speed.
(Forward)
High-speed Lock
• While holding down the D button to start high-speed clockwise
movement of the hands, press the B button to lock the
high-speed hand movement. You can then release the buttons.
• High-speed hand movement will continue until it completes a
12-hour cycle, or until you press any button to stop it.
• High-speed hand movement will also stop momentarily if an alarm
starts to sound. High-speed movement will resume after the alarm
stops.
3.
When the setting is the way you want, press the A A A A A
button.
• This exits the setting screen and automatically synchronizes
the minute hand with the current seconds count.
• The display also will exit the setting screen automatically if
you do not perform any operation for about two or three
minutes.