Linksys WRT54GS - Manual (Page 22)

Chapter3
Advanced Configuration
8 Wreless-G Broadband Router wth SpeedBooster
Log
Log To disable the Log function, keep the default setting,
Dsable. To monitor traffic between the network and the
Internet, select Enable.
When you wish to view the logs, click the Incomng Log
or Outgong Log button, depending on which you wish
to view.
Click the Save Settngs button to apply your changes, or
click Cancel Changes to cancel your changes.
Administration > Diagnostics
The diagnostic tests (Ping and Traceroute) allow you to
check the connections of your network components.
Administration > Diagnostics
Ping Test
Png The Ping test will check the status of a connection.
Click the Png button to open the Ping Test screen. Enter
the address of the PC whose connection you wish to test
and how many times you wish to test it. Then, click the
Png button. The Ping Test screen will show if the test was
successful. To stop the test, click the Stop button. Click
the Clear Log button to clear the screen. Click the Close
button to return to the Diagnostics screen.
The Ping Test
Traceroute Test
Traceroute To test the performance of a connection, click
the Traceroute button. Enter the address of the PC whose
connection you wish to test and click the Traceroute
button. The Traceroute Test screen will show if the test was
successful. To stop the test, click the Stop button. Click
the Clear Log button to clear the screen. Click the Close
button to return to the Diagnostics screen.
The Traceroute Test
Administration > Factory Defaults
The Administration > Factory Defaults screen allows you
to restore the Router’s configuration to its factory default
settings.
Factory Defaults
Restore Factory Defaults To reset the Router’s settings
to the default values, select Yes, and then click the Save
Settngs button. Any settings you have saved will be lost
when the default settings are restored.
Administration > Factory Defaults