Replacing the fuse, Warning – Weston Pro 1100 Vacuum Sealer User Manual

Page 17

-16-

REPLACING THE FUSE

If the Vacuum Sealer does not operate when it is plugged in and

turned on, try any or all of the following:
1. Make sure the

Fuse is not blown. The Fuse is located on the right

side of the unit directly above the

Power Cord Port. Turn “OFF” and

unplug the

Vacuum Sealer. Twist off and remove the Fuse Holder.

Remove and check the

Fuse. The thin metal band in the center of

the

Fuse should be clean and unbroken. If it is burned and/or broken,

replace it with a new

Fuse (8 Amp). Replace the Fuse Holder.

2. Make sure the

Connector at the end of the Power Cord is

plugged completely into the

Power Cord Port.

3. Make sure the

Power Cord is not damaged. DO NOT use

a damaged

Power Cord. Call the Customer Service line for

information on part replacement.

4. Try connecting the

Power Cord Plug to another electrical outlet.

WARNING!

Before cleaning, assembling or disassembling the Vacuum Sealer,

make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED FROM THE

OUTLET/POWER SOURCE!

Figure 13