Assembly – Weston Roma Deluxe Electric Tomato Strainer User Manual

Page 6

-6-

1. Hold the

Chute with the outlet tilted almost

fully downward and the head ring facing the

Motor

(figure 1).

2. Place the head ring of the

Chute over the round

raised face on the front of the

Motor. Position

the tabs on the head ring next to the slots in the

corresponding tabs extending from the round face

(figure 2).

3. Rotate the

Plastic Chute counterclockwise

until the tabs fit into the slots. The

Plastic Chute

should now be firmly held in place. When properly

positioned, the outlet of the

Chute should dip

slightly downward.

4. Assemble the round end of the

Drive Shaft

with a

Metal Washer, Spring, Metal Washer,

Plastic Bushing and the Beveled Rubber

Washer. (figure 3). NOTE: The Beveled

Rubber Washer has two sides, a flat side and the

beveled side. The beveled side fits onto the top of

the

Plastic Bushing like a cap (figure 3b).

5. Insert the square end of the

Drive Shaft into the

corresponding slot in the

Auger (figure 4).

6. Insert the

Auger/Drive Shaft Assembly into

the

Head.

7. Position the

Screen over the Auger. Line

up the tabs on the

Screen with the notches in the

Head. Hold the Screen in place.
8. Slide the

Front Ring Nut over the Screen

assembly and turn clockwise to firmly tighten

(make sure the tabs on the

Screen remain aligned

with the notches on the

Head). DO NOT over-

tighten the

Front Ring Nut to avoid damaging the

Motor during operation.

ASSEMBLY

Figure 2

Chute

Round, raised face on

the front of Motor

Tabs on

Motor

WARNING! Before cleaning, assembling or disassembling the Tomato Strainer,

make sure it is turned off “O” and disconnected from the power source. Test to make

sure there is no power to the

Motor by switching the Motor on “-” and off “O”.

Figure 1

Chute

Motor

Head

Ring

Figure 3

Drive Shaft Assembly

Figure 4

Drive Shaft

Assembly

Front

Ring Nut

Screen

Auger

Head

Figure 3b

Plastic

Bushing

Beveled

Rubber

Washer