Denon SC-CX303 - Manual (Page 6)

3
Connections Connections
ENGLISH
¢ Connecting to an amplifier with two sets of
speaker outputs (A+B)
• Set the speaker output selector switch to “A+B”.
Bi-wiring connections
The speaker system (SC-CX303) input terminals and circuitry allows
bi-wiring connections with the treble (upper tier) and bass (lower tier)
isolated and independent. This enables playback of high quality sound
without the audio signal interference resulting from the difference in
level between the treble and bass.
Use two connection cords per SC-CX303 unit.
Remove the short-circuit cords from the “+” and “–” sides.
¢ Connecting to an amplifier with only one set of
speaker outputs
• Also use this procedure to connect to amplifiers on which it is not
possible to output A and B simultaneously even if the amplifier
has two sets of outputs, or amplifiers on which the two sets of
outputs are connected in series.
To speaker “+” terminal
Twist the tip firmly
To speaker “–” terminal
• The SC-CX303’s impedance does not change even when using with
bi-wiring connections.
• For even more advanced enjoyment, if you have two amplifiers you
can set up a bi-amp drive system. In this case, set the outputs of the
two amplifiers to the same level.
CAUTION:
• If the amplifiers have different output levels, only the treble or
the bass will be emphasized and it will be impossible to achieve
the optimum balance between the two.
ENGLISH
Tweeter terminals
Woofer terminals
Connect to amplifier’s A speaker “+” side.
Connect to amplifier’s
A speaker “–” side.
Connect to amplifier’s
B speaker “+” side.
Connect to amplifier’s
B speaker “–” side.