Denon SC-CX303 - Manual (Page 5)

2
Getting Started
ENGLISH
ENGLISH
• There are various types of speaker output terminals on amplifiers.
Check your amplifier’s operating instructions.
• Raising the amplifier’s volume excessively and playing with distorted
sound could damage the amplifier and speakers. Enjoy the sound at
a reasonable volume level.
• When moving the unit, note that applying strong force to the surface
of the speaker through the saran net could damage the speaker.
Other cautions
• Note that the illustrations in this instructions may differ from the
actual set for explanation purposes.
Connections
When connecting, be sure to read the amplifier’s operating
instructions carefully and connect properly.
• Connect the input terminals on the rear panel of the speaker system
with the speaker output terminals on the amplifier, using the
connection cords (Supplied).
• Connect the speaker system for the left channel to the “L” terminal
on the amplifier, the speaker system for the right channel to the “R”
terminal on the amplifier, making sure to check the polarities (“+”
and “–”).
CAUTION:
• Be sure to turn the amplifier’s power off before connecting the
speaker systems to the amplifier.
• If the polarities are inverted, the phase may be off and the sound
may have no bass component, making it seem unnatural. Be sure
to connect the polarities properly.
• Once connections are completed, check that all of the short-
circuiting cords are securely connected to the terminals (“+” to “+”,
“–” to “–” on the woofer and tweeter sides).
Normal connections
“–” side
terminal: Black
Short-circuit
cord
“+” side terminal: Red
Twist firmly the wires by hand so that
they do not stick out and cause short-
circuits. 1
Loosen the terminal, insert the cord’s
core wire into the hole in the terminal,
then turn the terminal clockwise to
tighten it. 2
Even if nothing is connected to a
terminal, turn it clockwise to tighten
the short-circuit cord. 3
Sheath
Connect to amplifier’s
“+” side.
Connect to amplifier’s
“–” side. (Plain core)
CAUTION:
• Do not let the core wires of two connection cords touch each
other. Doing so will short-circuit the amplifier circuitry and
damage the amplifier.
• Once connections are completed, pull gently on the connection
cords to check that they are securely connected.
• The connection cords can also be connected to the terminals using
the included banana plugs.