Vortech maxflow, Power cooler, Tool & supply requirements – Vortech 1996-1998 Ford 4.6L Mustang Cobra User Manual

Page 3

Installation Instructions

Vortech Maxflow

Power Cooler

Congratulations on selecting the best performing and most

efficient aftercooler today... the Vortech

Maxflow Power Cooler!

The Vortech Maxflow Power Cooler system was designed as a street/strip oriented aftercooler,
specifically for use on 1996 - 1998 Ford 4.6 Mustang vehicles equipped with a Vortech supercharger
producing up to approximately 580 horsepower.

As with any power enhancing product, this system is intended for use on healthy, well-maintained
engines. Vortech Engineering is not responsible for engine damage. Installation on new vehicles
will not harm or adversely affect the break-in period so long as factory break-in procedures are
followed.

For best performance and continued durability, please take a note of the following key points:
1. Use only premium grade fuel 92 octane or higher (R+M/2).
2. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until

problem is resolved.

1996 - 1998 Ford 4.6 Mustang Cobra (4 Valve)

TOOL & SUPPLY REQUIREMENTS

• Open End Wrenches

(7/16”, 9/16”, 5/8”, 11/16”)

• 3/8” Ratchet

• 8mm, 13mm, 9/16”and 18mm Sockets

• 5/32”, 3/16”, 9/16” Allen Wrenches

• Flat #2 Screwdriver

• Phillips #2 Screwdriver

• Utility Knife

• Wire Cutters, Strippers and Crimpers

• Drill Motor

• 1/8”, #21 Drill Bits

• Tape Measure

• Pipe Tape (Teflon)

• Adjustable Wrench

IMPORTANT NOTE: If the vehicle still has the battery located in the factory position, it must be

relocated into the trunk to make room for the water tank assembly. Vortech part number

8N150-010 is a Heavy-Duty Battery Relocation Kit that may be purchased separately. Commonly
available “universal” relocation kits may be used but they will most likely contain a smaller cable.

Additional fabrication may also be necessary when using a “universal” kit.

Before beginning this installation,

please read through this entire instruction booklet