beautypg.com

Vortech 2006-2010 6.1L Hemi Cars (Charger, Challenger, Magnum, 300C) User Manual

Page 22

background image

P/N: 4CL020-010 v6.0, 02/28/2012

©2012 Vortech Engineering, Inc.

All Rights Reserved, Intl. Copr. Secured

8

A. (This step applies to 300C and 2008

Magnum vehicles only. All others skip

to step B) Install a ½” breather hose from the

engine to the hole in the air filter using the sup-

plied barbed fitting. Insert the air filter into the

space behind the driver side headlight for later

attachment to the supercharger inlet. (See Fig.

5-a)

B. Install the supplied 3” aluminum idler in the

lower 3/8-16 hole for the 6.1L and in the up-

per 3/8-16 hole for the 5.7L. Make sure that

the snap ring side is facing forward (away

from the mounting plate). (See Fig. 5-b).

2009-2010 5.7L Challenger models will use

inner most hole on mounting plate for idler

pulley.

C. Install the supplied power steering pump pulley

on the already installed hub using the supplied

1/4” hardware.

D. Install the supplied accessory drive belt (as

shown in Fig. 5-c).

E. Position the supercharger in front of the mounting

plate assembly in front of the engine and install

and tighten the four 3/8” x 1 ¼” bolts.

F. (This step applies to 300C and 2008

Magnum vehicles only. All others skip

to step G) Install the air filter onto the super-

charger inlet and tighten the clamp.

G. Install the supplied gilmer (toothed) belt around

the pulleys on the mounting plate assembly.

H. Using the supplied M12 x 100mm bolt, install

the supplied 3.5” aluminum idler with the bearing

retaining snap ring pointed towards the front of

the vehicle. The screw should pass through a flat

washer, S/C mounting plate, 1.55” idler spacer,

the idler, thick bearing washer, lock washer and

nut. Install the supplied nut and lock washer on

the end of the screw and tighten the idler so that

the gilmer belt is snug. (See Fig. 5-d).

I. Secure the remote drain hose away from the

belt and hoses using tie-wraps.

5.

SUPERCHARGER INSTALLATION

Fig. 5-b

Fig. 5-d

NOTE:

½” hose should point towards the pas-

senger side and then back under the

supercharger plate and up to the manifold

port.

Fig. 5-a

TRIM AS

NECESSARY TO

PROVIDE AIR FILTER

CLEARANCE ON

DODGE MAGNUM

BEND THESE LINES TO

PROVIDE AIR FILTER

CLEARANCE ON

DODGE MAGNUM

Fig. 5-c

6.1L

2005-2008 5.7L

2009 5.7L

This manual is related to the following products: