Dimplex Wall Switch Remote Control Kit WRCPF-KIT - Manual (Page 6)

6 www.dimplex.com
Locate the plastic 9-pin plug 6.
in the bottom corner of the
fireplace where the manual
controls were plugged in to.
Insert the plug connector from 7.
the remote control bracket
(Figure 4) into plastic plug
inside the fireplace.
ledge (Figure 2) and the logs
are resting against the partially
reflective glass.
Replace log grate using two
11.
(2) screws previously removed
in step 2.
Run black antenna wire under 8.
remote bracket and ensure
all wiring is placed such that
it does not interfere with re-
assembly.
Install the two (2) screws 9.
removed in step 4 into the
remote control bracket and
attach it to the fireplace.
Replace the log set by
10.
inserting front edge and
pushing the back down until
rear tab snaps under back
Figure 4
Remote Control
Plug
Connector
Antenna
Receiver Installation (BF units only)