Dimplex Wall Switch Remote Control Kit WRCPF-KIT - Manual (Page 15)

15
Initialization
DF3033ST and DFg3033 Models
1. Ensure that power is supplied
through main service panel.
2. Ensure the Main On/Off Switch
located in the switch box on
the fireplace in the upper right
hand corner is in the On
position (Figure 19A) .
A B C
Figure 19
DF3033ST / DFG3033
Manual controls
3. Set the 3 Position Manual
Control (Figure 19B) to the
Remote position (left position).
4. Press and hold the
Initialization Button on the unit
(Figure 19C) .
5. While holding the Initialization
Button, press any button
on the Wall Switch Remote
Control.
6. Release the Initialization
Button and button pressed
on the Control, sender is
initialized with the fireplace.
Operation
Manual Controls
The following instructions will
cover the operation of the manual
controls installed with the receiver
board contained with this kit
(BF unit installations). For the
operation of manual controls
for other installations (BLF50,
DF3033ST and DFG3033),
please consult your Owner's
Manual for those specific models.
The fireplace can be controlled
with switches located on the
receiver as shown in Figure 20.
! NOTE: Firebox must have
the Main On/Off and mode
selector switch in the full on
position for all features to work
properly.