Dimplex Wall Switch Remote Control Kit WRCPF-KIT - Manual (Page 14)

14 www.dimplex.com
Initialization
After installation, locate the
section which applies to your
specific model of fireplace and
follow the steps for remote control
initialization and if required,
re-initialization. Refer to your
fireplace's owner's manual to
locate manual or other controls as
needed.
BF Models Using the Included
Receiver Module
1. Ensure that power is supplied
through main service panel.
2. Inside the fireplace, locate the
toggle switch on the manual
controls and set to “Remote”
(Figure 17-C).
4. Press any button on the Wall
Switch Remote Control within
that 10 seconds.
BLF50 Models
1. Ensure that power is supplied
through main service panel.
2. Inside the fireplace, turn Main
On/Off Switch to Off
(Figure 18-A) and wait 10
seconds.
3. Move the Three Position
Switch (Figure 18-B) to the
“ REMOTE ” position.
Figure 17
A B C
D E F
3. Press and hold the On button
on the manual controls
(Figure 17-A) for five (5)
seconds. The Level 1
Indicator Light (Figure 17-D)
will then flash for 10 seconds.
Figure 18
B A
BLF50 Manual controls
4. Turn Main On/Off Switch to On.
5. Press and hold the Manual
Control Button marked “
I ” (Figure 18-C) for five
(5) seconds. After five (5)
seconds, there is a 10 second
window to press any button on
the remote control.
6. Press any button on the Wall
Switch Remote Control within
that 10 seconds.
C