UVP 81-0117-01 EL Series Lamps - Manual (Page 6)

EL Series UV Lamps Page 6
Service Procedures
Return Procedure
A Returned Goods Authorization (RGA) number must be obtained from UVP Customer Service
before returning any product to UVP.
Replacing Tubes

Disconnect the lamp from the electrical supply before replacing tubes.

Remove the two Phillips head screws located in the end cap.

Grasp the extruded housing and slide the chassis and filter out together away from the switch.

Disconnect the interior Molex connector and slide the chassis and filter out from the housing
completely (Fig. 1).

Once out of the extrusion, the chassis and filter will come apart.

Carefully grasp the tube ends and twist one quarter turn until the tube works free (Fig. 2)

Insert the new tube, twisting 90° to lock in place.

Reconnect the interior Molex connector and reassemble the lamp. Do not pinch wires during
assembly.
Figure 2
Ground
Wire
Figure 1
Chassis
Filter
Housing
Molex
Connector Screw